The best way to Cover a Dresser

No matter how superbly the relaxation of your space is adorned, an old, beatup dresser is an eye-sore that detracts from it. If you don’t have the money to change it, re-finish it. If paint can’t even disguise an unsightly dresser, re-finish it with material to get a chic and easy makeover. Luxurious cloth and rich can include a pop of texture, pattern or colour to your own furniture that is old to create a showpiece for the home.

Get samples or cloth swatches to bring check and home. You’ll require a material of all or largely organic fibers, using a medium to tight-weave.

Test material for colorfastness. Brush on medium liberally using a sponge applicator. Consider an alternative fabric in the event the colours run poorly. It’ll work fine when there’s very gentle to no colour bleed.

Mark and measure down duration and the width of every section you plan to protect. This may include side panels, leading area, the drawer faces, legs or some framework that is exposed.

Calculate the minimal square footage of material it is going to try cover the dresser. Multiply the height by the width of every surface that is measured, and add each of the results. In the event that you measured in inches, divide the solution to get the square-footage.

Add 20-percent to the measurement for extra in the event of errors. If you’re operating with material that wants matching, include 40% when buying your selected material. Bring it home, clean it, iron it easy and dry it.

Use a pencil or marking chalk to mark the back of the cloth using the measurements that are recorded. Each dresser area will be suit by check always measurements to make certain each material part completely.

Spread the cloth on a low-cost plastic tarp outside. Weigh down the corners with bricks or cans. Spray it with a coat of obvious acrylic sealer and permit it to dry. Spray the reverse facet and flip it, then allow it dry. The sealer makes it stiffer therefore it’s simpler to manage, minimizes fraying and makes the material mo-Re color-fast.

Remove the dresser’s components and sand the surfaces you program to cover. Whether your dresser is laminate, wood or plastic, you want to dull any shine on the surface to promote adhesion. Wipe the surfaces using a moist fabric and allow the dresser dry.

Cut out the cloth sections according to the measurement markings. Brush material decoupage medium on one dresser area having a sponge applicator. Position the material piece over it s O all of the edges satisfy flawlessly, trimming a way extra if required.

Use a brayer or outdated rolling-pin to flatten the cloth and workout air bubbles and wrinkles. Cover each area in change. Apply an ultimate coat of decoupage medium over each area and allow them dry completely.

Run your finger over the material to discover the holes. Make an “X” using a craft knife through the material in order to screw in the drawer pulls or hinges.

See related