The best way to Remove & Change a PVC Closet Flange

If you can’t remedy a rocking bathroom by tightening the flange bolts, it could be the PVC plastic closet flange is unable to to keep down the bathroom. In case you discover the flange is therefore separated that the repair package can’t be employed, the flange has to be replaced. Installing a closet flange that is new is a task that is straightforward.

Shut off the water-supply to the bathroom, disconnect the waterline in the tank, lift the bathroom off, un-do the bolts using a wrench and set it apart. Clean.

Install the pipe cutter that is the inner in the chuck of your electrical drill and reduce the PVC drainpipe just. Internal pipe cutters are sold at plumbing supply shops and home centers. Undo any screws holding the flange that is old to the ground and raise out the aged flange.

Obtain a fresh PVC flange having a neck that fits tightly in the drainpipe. Most homes use both 4-inch PVC or 3-inch drainpipe for bathrooms. Test fit the flange that is new. Before the aspect slots for the bolts are parallel using the wall turn the flange. Mark the area of the slots using the marker.

Pull up the flange, coat the neck therefore the aspect slots line up with all the marks on the ground and set the flange into the drainpipe. Screw the flange to the ground together with the #10 flat head wood screws as well as the screwdriver.

Lay a new wax ring on the flange that was new, cautiously set the bathroom on the flange and ring, tighten the bolts, re-connect the water-supply and turn the water back on. Flush the bathroom and verify that it doesn’t rock or leak and operates properly.

See related