Home

Refrigerator Door Handle Repair

The point at which the door handle attaches to the refrigerator is usually well-hidden, building a repair seem more complicated than it really is. Should you inspect the manage carefully, however, you can usually locate the screws which hold it in place or at least the panel which covers the screws.

Screws and Tracks

Inspect the manage to discover the attachment point. If you’re able to see the screws, use an Allen wrench or screwdriver to tighten the screws to repair a loose manage, or remove them and replace a cracked handle. When the screws are hidden, try sliding the handle up or to the lefthand. Do not put so much pressure that it will damage or break the grip, but use enough to determine whether it slides away on a track or is attached by screws. Slide off the handle if it is not screwed on, and tighten the screws on the tracks, or remove the whole assembly if you’re replacing the grip. To get a handle attached by screws, look for a tiny removable panel. The panel might slide out of the way or you might want to gently pry it away. Remove the panel and tighten the screws, or loosen them to remove the handle.

Home

The way to Caulk the Cracks in the Walls of a Fireplace

The sides and back wall of a standard wood-burning fireplace are built using fire bricks and mortar. Over time, excessive heat can adversely impact cement, causing the joints to crack or flake. In the event you become aware of bits of mortar on the ground Flagstaff of a fireplace, flattening the cracks employing a silicate-based refractory cement caulking that disables heat. Preparation is the trick to effectively caulking the cracks in a fireplace.

Wear work gloves, a dust mask and safety glasses. Protect the hearth and adjacent flooring or carpeting, using a drop cloth. Open the fireplace display completely and eliminate the log grate from the fireplace.

Eliminate debris and ash from the floor of the fireplace, employing a wet-dry vacuum. Eliminate soot from the mortar joints in the sides and rear walls of the fireplace, employing a stiff-bristle brush.

Inspect the vertical and horizontal mortar joints for cracks or flaking. Eliminate loose mortar at these regions, employing a 3-inch cold chisel and hammer. Use the brush to remove any remaining brick from the subjects of repair. Clean the debris up with the vacuum.

Set up a caulking gun with a tubing of silicate-based refractory cement caulking. Cut off the tip of the tubing to make a 1/8-inch opening, using a utility knife.

Caulk the ready areas in the mortar. For your best results, use a continuous motion as you draw the tip of the tubing along a crack. You might have to use a number of layers to get wider cracks. Permit the caulking to dry before using the fireplace.