Schiller Grounds Care has been fabricating the Bobcat brand of consumer and commercial riding lawnmowers because the 1970s. The buckle on the Bobcat mower cutting deck demands periodic replacing as it will become worn or fragile. The cutting deck buckle on a Bobcat riding lawnmower is readily available, but it’s very important to take an image or pull a diagram of their belt routing to utilize as an reference when installing a new belt.
Park the Bobcat riding lawnmower and switch the ignition off key on the operator’s right side control panel beside the seat. Catch the Power Take-off button into disengage the mower deck blades. The button is on the ideal side of the operator’s control panel, just above the ignition switch. Pull up the parking brake lever to engage the brake; the lever is on the left side before the seat. Disconnect the spark plug wire from the spark plug. These actions stop the mower from moving or beginning as you work on the belt.
Unscrew the bolts from the floor pan using a socket. Lift the ground Flagstaff pan from the chassis by hand to acquire entry to the cutter deck belt and pulleys.
Lower the cutter deck to the center place to permit for belt elimination. Lift the cutter deck up; push the cutter deck lift lever forwards to the center place.
Find the cutter deck idler pulley through the floorboard opening; the pulley sits on top of the ideal side of the deck. Clip a very long 3/8-inch extension pub on a 3/8-inch ratchet wrench. Insert the extension square end into the square hole in the pulley arm.
Establish the ratchet wrench direction control knob to the “loosen” place. Expand the ratchet wrench fully to the left to swing the idler arm backward, relieving the belt tension. Hold the ratchet wrench with one hand as you slide the belt from around the idler pulley. Unthread the aged belt from around the remaining Power Take-off pulley, idler pulley and spindle pulley. Slide the belt out from the floorboard opening.
Fit the new belt around the Power Take-off pulley, inserting the side of the new belt fully into the pulley groove. Pull the new belt back, and track it around the left side idler along with spindle pulleys. Pull the new belt around the ideal side spindle pulley, and pull it tight toward the ideal side idler pulley.
Turn the ratchet wrench fully to the left to ease the ideal side idler pulley tension; hold the rhythm in position. Slip the belt around the idler pulley. Slowly release the hold to the wrench to tension the belt.
Set the floorboard on the chassis. Tighten the floorboard retaining bolts using a socket wrench. Start the mower. Engage and disengage the cutter deck many times to check for suitable belt surgery.
