Home

How to Hang Anaglypta

Anaglypta is a cotton fiber and paper pulp raised-design wallpaper that may be pasted to walls or ceiling and painted or left in its natural white state. It supplies a decorative finish which could mimic elaborate flocking or pressed tin ceiling tiles. Hanging it presents a few challenges as the paper is heavier than standard wallpaper and also — while the increased pattern is resilient — you can not apply too much pressure when smoothing it down.

Clean and repair the walls to be painted, filling in any cracks and removing any peeling paint or old wallpaper remnants.

Prime or hang liner paper on the walls that’ll be dealt with in anaglypta. Lining paper is broader than standard wallpaper rolls to prevent seam overlap, and provides a secure gripping surface for the heavier, decorative anaglypta. You can adhere anaglypta to just a primed finish, if you would like.

Center a bold pattern on the anaglypta on the most apparent wall — the one you see when entering the room or also the section over a chimney breast, like. For a more small repeat pattern, assess the wall length commencing at the most well-lit corner and cut the first length of paper a minimum of two inches longer than needed to permit for trimming and pattern matching.

Apply strong adhesive paste to the wrong side of the length of wallpaper. Work from the middle of the paper toward the exterior to avoid getting paste on the front of the anaglypta. Use a paste recommended for hanging heavier, ornamental newspapers like anaglypta. Book the paper by folding it, pasted sides together, from bottom to middle and top to middle. Permit the pasted paper sit for a couple minutes so that the glue is absorbed.

Preserve up the paper the ladder folded loosely — do not crease it — then unfold it and paste it into the wall. Hang the paper in the ground Boise down, trimming the bottom and top and tamping down the edges gently with the back of a wallpaper brush. Don’t smooth the paper level to the wall with any pressure which could crush the patterns that are raised. Match the next length of paper into the sheet hanging on the wall to ensure that the design lines up correctly, and repeat the cutting and booking procedure.

Paint or faux finish the anaglypta to coordinate with your decor, when the wallpaper has dried in position. Anaglypta is quite sturdy but you ought to avoid unnecessarily saturating or overloading it with finishes or paint, without adequate drying times, therefore it will remain securely fixed to the wall.